Need help?Do you have a question about the Mitsubishi D700 VFD and is the answer not in the manual?
General| Output Frequency | 0.2 to 400 Hz |
|---|---|
| Overload Capacity | 150% for 60 seconds |
| Communication | RS-485 |
| Braking Unit | Built-in |
| Input Frequency | 50/60 Hz |
| Rated Output Current | Varies by model |
| Cooling Method | Fan Cooled |
| Humidity | 95% RH or less (non-condensing) |
| Enclosure Rating | IP20 |
| Weight | Varies by model |
| Input Voltage | 200-240V |
| Control Method | V/F Control |
| Protection Features | Overcurrent, overvoltage, overheating |
| Operating Temperature | -10°C to +50°C |
| Output Voltage | 0-Input Voltage |
| Power Rating | Varies by model |
| Storage Temperature | -20°C to +65°C |
| Altitude | Up to 1000 m |
Explains the Cat5 control cable connection between the breakout board and the VFD, detailing wire color to VFD connection.
Instructions on connecting the spindle motor wires to the VFD terminals (U, V, W) and how to reverse direction.
Information on selecting and connecting a brake resistor based on motor HP, including a table and connection diagram.
Guide to navigating the VFD user interface and the procedure for setting parameters in PU mode.
Lists parameters that should not be changed and those that may require adjustment based on motor specifications.
Instructions for performing auto-tuning on the VFD, especially if the spindle is not working well.
Step-by-step guide to testing the spindle motor directly from the VFD using the interface.
Explains how to configure Mach3 by setting spindle RPM and pulleys to match the VFD's analog output.
Describes using M-codes (M41-M45) and outputs (12-16) for changing pulleys or gears within Mach3.
Instructions on setting the spindle speed in Mach3 and initiating the spindle operation.
Explains manual control via FWD/REV buttons and programmatic control using M-codes (M3, M4, M5).
Method for calibrating spindle speed using a tachometer or feedback, involving calculating a new velocity value.
Method for calibrating spindle speed without feedback, using VFD frequency and Mach3 pulley settings.
Provides a step-by-step guide for diagnosing and resolving issues when the spindle is not turning on.
Lists VFD error messages, warnings, and fault codes, their descriptions, and corrective actions.
To Next Page