8 | P a g e
Brake Resistor
If you want a brake on your spindle, you will need a brake resistor. Use the table below to locate the correct
resistor size. You can order them directly from Mitsubishi.
Motor (Hp)
Resistance (Ohms) Continuous Power (W) Mitsubishi Part #
1/2 200 60 FR-ABR-0.4K
1 100 80 FR-ABR-0.75K
2 & 3 60 120 FR-ABR-2.2K
5 40 155 FR-ABR-3.7K
7 1/2 25 185 FR-ABR-5.5K
10 20 340 FR-ABR-7.5K
If you have a brake resistor, connect it between PR and P/+ on the VFD.
Figure 4 Brake Resistor
Note: Each VFD model is slightly different. Just make sure that you connect the resistor to the correct terminals
(PR, P/+).
To Next Page
Loading...
