Features and controls
3-43
3
Selector lever positions (Main gate)
N00514200213
“P” PARK
This position locks the transaxle to prevent the vehicle from
moving. The engine can be started from the “PARK” position.
“R” REVERSE
Move the lever to this position only after the vehicle has come
to a complete stop.
“N” NEUTRAL
At this position, the transaxle is disengaged. It is the same as
the neutral position on a manual transaxle and should be used
when the vehicle is not moving for an extended length of time
during driving, such as in a traffic jam.
“D” DRIVE
This position is used for most city and highway driving. Engine
shifting and braking are done automatically as needed, depend-
ing on road conditions.
OTE
● For information on manual gate operation, please refer to
“Sports mode” on page 3-44.
CAUTION
!
● If the light comes on while driving, reduce the
engine speed and stop the vehicle in a safe area.
Then set the selector lever to “P” (PARK) position
and idle the engine until the warning light goes off.
When the warning light goes off, resume normal
driving. If the warning light does not go off, have
your vehicle inspected by an authorized Mitsubishi
Motors dealer or a repair facility of your choice.
CAUTION
!
● Never shift into the “P” (PARK) or “R”
(REVERSE) position while the vehicle is in motion.
If the lever is shifted into the “P” or “R” position
while the vehicle is in motion, the transaxle may be
damaged.
WARNING
!
● Never move the selector lever to the “N” (NEU-
TRAL) position while driving since you could acci-
dentally slip it into the “P” (PARK) or “R”
(REVERSE) position, damaging the transaxle.
● To prevent the vehicle from rolling when stopped on
a slope, the engine should be started in the “P”
(PARK) position, not in “N” (NEUTRAL).
● Always keep your foot on the brake pedal when the
vehicle is in “N” (NEUTRAL), or when shifting into
or out of “N” (NEUTRAL), to prevent rolling.
BK0121600US.book 43 ページ ２０１０年４月１２日 月曜日 午前１０時３９分
To Next Page
Loading...
