iiiiii
2.2. How How to Uto Use Tse This his ManManualual
2.2.11 TrTrucuck Mok Modedell
(19)(19) Tighten connections to thTighten connections to the correct torquee correct torque. Make sure. Make sure
that all heat shields, clamps and guards are installedthat all heat shields, clamps and guards are installed
correctly to avoid excessive heat, vibration or rubbingcorrectly to avoid excessive heat, vibration or rubbing
against other parts during operation. Shields thatagainst other parts during operation. Shields that
protect against oil spray onto hot protect against oil spray onto hot exhaust componentsexhaust components
in event of a line, tube or seal failure, must be installedin event of a line, tube or seal failure, must be installed
correctly.correctly.
(20)(20) Relieve all pressure Relieve all pressure in air, oil or water systein air, oil or water systems beforems before
any lines, fittings or related items are disconnected orany lines, fittings or related items are disconnected or
removed.removed.
Place blocks to prevent a device from falling if it is in Place blocks to prevent a device from falling if it is in thethe
raised position. Release the residual pressure whenraised position. Release the residual pressure when
removing a pressurized device.removing a pressurized device.
(21)(21) Do not operate a truDo not operate a truck if any rotating part is damageck if any rotating part is damagedd
or contacts any other part during operation.or contacts any other part during operation.
Any high speed rotating component that has beenAny high speed rotating component that has been
damaged or altered should be checked for balancedamaged or altered should be checked for balance
before reusing.before reusing.
MC Truck (Manual Control System)MC Truck (Manual Control System)
Mechanically controlled hydraulic system (conventionalMechanically controlled hydraulic system (conventional
lever system)lever system)
501489
501489
FC (Fingertip Control System) TruckFC (Fingertip Control System) Truck
This model allows a fingertip operation of lifting This model allows a fingertip operation of lifting and tiltingand tilting
jobs, and majobs, and may improve y improve the job ethe job efficiency with fficiency with less operatioless operationn
fatigue.fatigue.
501490
501490
Connector numberConnector number
A connector number is allocated to each connector.A connector number is allocated to each connector.
Refer to the CHAPTER 5 CIRCUIT DIAGRAM or Refer to the CHAPTER 5 CIRCUIT DIAGRAM or the connectorthe connector
number.number.
To Next Page
Loading...
