Mitsubishi FREQROL FR-A024-1.5K

22. PARAMETERS
Pr.79
Wer: 3. In the edit enable signal mode, the idlowing functions are avdable. (Refer to page 35.)
lnthr extW operation mode. ocgxrt is shut on.-
Operation mode can be awildwd to the PU mode.
* In the PU mode, values set for parameters can be changed.
1 1
7
Operation in the PU operation mode is embkd.
Operation mode is forcibty chsnged to the external
operation
mode.
Open
Operation mode change to the PU operatton mode is
Operation in the external operation mode is enabled.
4. In IOcaVauto external signal selection mode selection is made as indicated below. (Refer
to page 37.)
Mode change is not allowed during operation. Change the mode only while the inverter is
stopped.
(RH and SD)
Slgnal
yod.
External operation mode only
‘Iosed
(not switchable
to the PU operation mode)
R
1- I Open I
PU operation mode only
(Not switchable to the external omration mode)
m,
w
h
w
4
-88-