Installation of the receiver
③
How to install the receiver(continued)
①
Connect the wire connector (Communication) to CNB on PCB.
②
Connect the wire connector (Receiver) to CN3 on PCB.
③
Install the PCB mounting supports on the bracket (Sheet metal).
④
Install PCB on the PCB mounting supports.
⑤
Insert the bracket (Sheet metal) in one side of control box, and fix the other side with screws as
shown in the figure.
⑥
Connect round terminals of wires (Communication) to the terminal block (X, Y) in the control box. The
wi
res have no polarity.
⑦
Fix wires with bands as shown in the figure.
⑧
Cut off the half-blanks on the panel (at 4 places) as shown in the figure.
⑨
Pass the wiring (Communication) through the opening on the panel.
⑩
Connect connectors of the wiring (Communication) and the receiver.
⑪
Install the receiver on the panel according to the installation manual of the panel.
⑫
Install the control box lid with care not to pinch wires, and fix with screws (2 pcs.).
⑨
⑩
③
①
②
Installation of ④, ⑤ brackets (Sheet metal)
(Insert)
Cut off at 4 places.
Bracket (Sheet metal)
Bracket mounting
screw
PCB mounting support
Wiring
(Receiver)
hook
⑧
⑥
PCB
Wiring
(Communication)
⑦
To Next Page
Loading...
