④
Wireless remote control
Installation tips for the remote control holder
Fix the remote control holder using the screws supplied
with this product.
* Precautions for installing the holder
• Adjust the position so that it is upright.
• Ensure that the screw heads are not protruding.
• Do not attach the holder on plaster wall.
How to insert batteries
1. Detach the back lid.
2. Insert the batteries. (two AAA batteries)
3. Reattach the back lid.
Setting to avoid mixed communication
1. Detach the back lid, and remove the batteries.
2. Cut off the switching wire in the battery compartment using nippers.
3. Insert the batteries, and attach the back lid.
Changing the remote control setting
How to change the Auto Run setting
The Auto Run mode is not available on the building air-conditioning and gas heat
pump series (excluding the cooling/heating free multi system).
When using the remote control to operate those models, set the remote control
to disable the Auto Run mode.
To disable the Auto Run mode, press the
ACL
switch while holding down the
MODE
button, or insert batteries while holding down the
MODE
button.
* Note: Once the batteries are removed, the setting is reset to the factory default.
.evoba debircsed spets eht taeper ,devomer era seirettab eht nehW
Indoor function settings
1. How to set indoor functions
①
Press the ON/OFF button to stop the unit.
②
Press the desired one of the buttons shown item 2. while holding down the
FUNCTION SETTING switch.
③
Use the selection buttons
▲
and
▼
to change the setting.
④
Press the SET button.
The buzzer on the remote control signal receiver beeps twice, and the LED
lamp flashes four times at two-second intervals.
Wood screw
To Next Page
Loading...
