-
329
-
Inside unit PCB
Do not install the motion sensor kit at the following places in order to avoid malfunction.
(1) Places exposed to direct sunlight
(2) Places near heat devices
(3) High humidity places
(4) Hot surface or cold surface enough to generate condensation
(5) Places exposed to oil mist or steam directly
(6) Uneven surface
(7) Places affected by the direct air flow of the AC unit
(8) Places where the motion sensor is influenced by the fluorescent lamp(especially inverter type) or sunlight
(9) Places where the motion sensor is affected by infrared rays of any other communication devices
(10) Place that the motion sensor have a shock
(11) Place with the strong radio wave or static electricity
(12) Place that motion sensor lens become tainted or have damaged.Dusty place
(13) Do not run in parallel with strong voltage lines such as power source wiring
1
4
White
Black
3
Red
<In case of CnL connector is not on PCB>
Connected wiring
(Prepare on site)
1
3
White
Black
Red
<In case of CnL connector is on PCB>
2
Sensor
CnG
Blue
CnV2
Black
Connected wiring
(Prepare on site)
To connect
the accessory
Inside unit PCB
To connect
the accessory
CnL
Black
White
Black
Red
White
Black
Red
Sensor
(In case of “DC motor”)
1
4
White
Black
Red
<In case of CnL connector is not on PCB>
Connected wiring
(Prepare on site)
White
Black
Red
Sensor
CnG
Blue
CnV
Black
To connect
the accessory
Inside unit PCB
(In case of “AC motor”)
5
[Refer to Note (5)]
[Refer to Note (5)]
Installation precautions
Wiring connection
To Next Page
Loading...
