Mitsubishi KXZ Series - Page 339

-
337
-
'20 • KX-T-373
●
Refer to the installation manual for wireless remote control to enable motion sensor in
Indoor function settings
Control setting (from wireless remote control)
Indoor function settings
1. How to set indoor functions
①
Press the ON/OFF button to stop the unit.
②
Press the desired one of the buttons shown item 2. while holding down the
FUNCTION SETTING switch.
③
Usetheselectionbuttons,▲and▼,tochangethesetting.
④
Press the SET button.
The buzzer on the remote control signal receiver beeps twice, and the LED
lampashesfourtimesattwo-secondintervals.
1
4
2
3
2
2
2. Setting details
Button
Number
indicator
Function setting
SILENT
00 Infrared sensor setting (Motion sensor setting) : Disable
01 Infrared sensor setting (Motion sensor setting) : Enable
HI POWER
00 Infrared sensor control (Motion sensor control) : Disable
01 Infrared sensor control (Motion sensor control) : Power control only
02 Infrared sensor control (Motion sensor control) : Auto OFF only
03 Infrared sensor control (Motion sensor control) : Power control and Auto OFF
●
Refer to the installation manual for eco touch remote control to set control mode.
■ Infraredsensor(motionsensor)control(forIUswithmotionsensors)
Presence of humans and the amount of motion are detected by a motion sensor to perform various controls.
■ WhentheR/CissetasthesubR/C,theinfraredsensor(motionsensor)controlcannotbeset.
TOP screen
Menu
_
Service setting
_
Installation settings
_
Service password
Control setting (from eco touch remote control)
●
Refer to the installation manual for eco touch remote control to activate the infrared sensor (motion sensor).
Tap the
Menu
button on the TOP screen and select
Energy-saving setting
_
Infrared sensor control
or
Motion sensor control
.
The Infrared sensor control screen and contents of the current settings are displayed.
①
Enable/disable power control.
②
Enable/disable auto-off.
③
After you set each item, tap the
Set
button.
The display returns to the Energy-saving setting menu screen.
* This control will not be executed unless
③
is performed.
Infrared sensor control
Set
Back
Enable
Disable
Enable
Disable
Select the item.
Power control
Auto-off
1
2
3
② Installation settings menu #2
Installation settings
Address setting of main IU
IU back-up function
Infrared sensor setting
Previous Back
Select the item.
14
13
17
⑰ Infrared (motion) sensor setting
Select the item.
Infrared sensor setting
Disable
Enable
Back
Menu
Direction
Cooling
16:14 (Mon)
F1: High
power
F2: Energy-saving
Timer
Now stopping.
Set temp