-
336
-
SAFETY PRECAUTIONS
●
If a child, person with disease or other persons needed
for assist uses this product, people around the person
should take sufcient care.
A halt of the air-conditioner due to abnormal situation or motion
s
ensor’s control may cause a feeling of sickness or accident.
WARNING
• The sensor may not detect a person near the border of detection range.
•
Installation near an object with a different temperature from the surrounding
may cause a false detection of human.
• Due to correction of temperature setting, some people may feel chilly.
ATTENTION
This product uses infrared sensor to detect person’s activity level to support control of air-conditioner.
Please set the control you like from the remote control.
Indoor unit control Detective situation Description of control
Display of eco touch
remote control
①
Power control
Activity level is large
Lower the indoor temperature
setting for comfort.
Power control ON
Activity level is small
Raise the indoor temperature
setting for energy-saving.
Power control ON
②
Auto-off
No one is detected for 1 hour Stop operation and stand by In auto-off mode
No one is detected for 12 hours Stop operation -
①
+
②
Any combination of the above Any of the above Any of the above
All disabled
(default setting)
- Standard control -
If the sensor is disconnected or defective, the control will be set as if it no detects (or less) activity level.
•
When auto-off is enabled
The unit will enter the "operation wait" state when an hour has elapsed since
the last time a human presence was detected.
And will be in "complete stop" state after 12 hour of operation wait time.
•
When power control is enabled
The amount of human motion is detected by a motion sensor to adjust the Set temperature.
(The set temperature of remote control is displayed at the adjusted temperature.)
in cooling : 33 °C, in heating : 15 °C
adjust the set temperature seep by step up to above temperature.
During power control, “Power control ON” will be displayed on the message
display.
Menu
Direction
Heating
20:20
(Tue)
F1: High power
F2: Energy-saving
Timer
Power control ON
Set temp
Menu
Direction
Cooling
16:32
(Mon)
F1: High power
F1: High power
F2: Energy-saving
F2: Energy-saving
Timer
In auto-off mode
Set temp
“Operation wait”... The unit stops but will resume operation when human presence
is detected. When the unit is in “Complete stop”, “In auto-off
mode” will be displayed on the message display.
“Complete stop”...
When auto-of
f is enabled, the unit stops. The unit will not
resume operation even when human presence is detected.
The message “In auto-off mode” will disappear from the message
display, and the operation lamp will turn off.
Refer to the next section for setting method.
(4) User’s manual
PJZ012D134
To Next Page
Loading...
