NOTE
l
The
high-beams can also flash when the
lamp switch is in the “OFF” position.
l
If you turn the lamps off with the headlamps
set to high-beam illumination, the headlamps
are automatically returned to their low-beam
setting when the lamp switch is next turned
to the “
” position.
Headlamp levelling switch*
E00506400826
The
angle of the headlamp beam varies depending
on the load carried by the vehicle.
The headlamp levelling switch can be used to ad-
just the headlamp illumination distance (when the
lower beam is illuminated) so that the headlamps’
glare does not distract other drivers.
Set the switch (referring to the following table) to
the appropriate position according to the number of
people and the load in the vehicle.
CAUTION
l
Always
perform adjustments before driv-
ing.
Do not attempt to adjust while driving, as
it could cause an accident.
NOTE
l
When
adjusting the beam position, first put
the dial in the “0” position (the highest beam
position).
Single cab
Vehicle condi-
tion
Switch position “0” “2”
●: 1 person
: Full luggage loading
Switch position 0- Driver only
Switch position 2- Driver + Full luggage load-
ing
Club cab
Vehicle condi-
tion
Switch position “0” “3” or“4”
●: 1 person
: Full luggage loading
Instruments and controls
3-32
3
To Next Page
Loading...
Need help?
General
