Mitsubishi LT2-230 - Wiper Adjustment

] Wiper adjustment
(1) Set stitch length dial to "5" and stop the
sewing machine with the needle at UP
position.
(2) Loosen the screw @ and adjust the link
to be parallel with the bed surface, as
shown in Fig.
(3) Loosen the screw (§) and turn the wiper
shaft to adjust so that gap between the
tip of wire and needle point is within a
range from 1.5mm to 2mm.
(4) Loosen the nut (e)and turn the screw®
to adjust the clearance between the wiper
point and the presser foot becomes about
2 mm when the link is pushed by finger as
shown
(5) Pass each needle thread through needle eye.
(6) Loosen the screw © and move the wiper
0.5 mm leftward or rightward to adjust so
that thread can be securely hopked by the
wiper.
Caution: For a gauge size over 5/8" (16 mm),
replace with the separate wiper shaft.
Screw© Screw
Wiper
Needle
Approx.
2 mm
Screw®
Screw®
Wiper shaft
Wiper
Presser Wiper
foot
Approx. 0.5mm ——Approx. 0.5mm
-21 -
Needle
1.5 ~ 2.0 mm
Link
Nut(D
Set screw
0
From the library of: Superior Sewing Machine & Supply LLC