4 - 20
CPU MODULE4.
List of parameter setting range (From the previous page)
Item Default value
Setting range
A2USHCPU-S1
A2ASCPU-S30
A2USCPU
A2ASCPU
A2USCPU-S1
A2ASCPU-S1
Timer settings
T0 to T255
T0 to T199
(100ms)
T200 to
T255(10ms)
256 points by 100ms, 10ms, and retentive timers (in 8 point units)
Timers are serial numbered.
T256 to T2047 –
1792 points by 100ms, 10ms, and retentive timers (in 16 point units)
Timers are serial numbered.
Devices set: D, R, W (Setting required if 257 points or more.)
Counter
setting
Interrupt counter
setting
–
Sets whether to use interrupt counter (C224 to C225) or not.
Points used
256 points
(C0 to C255)
0 to 1024 points (in 16 point units)
Devices set: D, R, W (Setting required if 257 points or more.)
I/O assignment –
0 to 64 points (in 16 point units) ............
Input module/output module
special function module/empty slot
Module model name registration is possible.
Remote RUN/PAUSE contact
setting
–
X0 to X1FFF
RUN/PAUSE ....... 1 point (PAUSE contact setting is not only allowed.)
Operating
mode when
there is an
error
Fuse blown Continue
Stop/Continue
Module
comparison error
Stop
Computation
error
Continue
Special function
access error
Stop
Data communication request
batch processing
None Yes/No
Output mode switching at
STOP RUN
Output data at
time of STOP
restored
Output before STOP/after operation
Print title regisration –
128 characters
Keyword registration –
Up to 6 characters in hexadecimal (0 to 9, A to F)
MELSECNET/
10 link range
setting
Number of link
stations
–
Optical link ...... Max. 64 stations
Coaxial link ..... Max. 32 stations
I/O (X/Y) X/Y0 to X/Y1FFF (unit: 16 points)
Link relay (B)
A2USHCPU-S1, A2USCPU, A2USCPU-S1: B0 to B1FFF (unit: 16 points)
A2ASCPU, A2ASCPU-S1, A2ASCPU-S30: B0 to BFFF (unit: 16 points)
Link register (W)
A2USHCPU-S1, A2USCPU, A2USCPU-S1: W0 to W1FFF (unit: 1 point)
A2ASCPU, A2ASCPU-S1, A2ASCPU-S30: W0 to WFFF (unit: 1 point)
To Next Page
Loading...
Need help?
General
