11 - 14
TROUBLESHOOTING11.
Table 11.1 Error Code List for the AnUCPU, A2US(H)CPU, A2ASCPU and A2USH board (Continue)
Error Massage
Error
Code
(D9008)
Detailed
Error
Code
(D9091)
CPU
States
Error and Cause Corrective Action
"CAN'T
EXECUTE (P)"
(Checked at
execution of
instruction.)
13 131 STOP The same device number is used at two
or more steps for the pointers (P) and
interrupt pointers (I) used as labels to
be specified at the head of jump
destination.
Eliminate the same pointer numbers
provided at the head of jump destination.
132 Label of the pointer (P) specified in the
the , , , , ,
or
instruction is not provided before the
instruction.
Read the error step using a peripheral
device, check contents and insert a jump
destination pointer (P).
133 (1) The instruction was included
in the program and executed
though the instruction was
not given.
(2) The
instructions were included in the
program and executed though the
instruction was not given.
(3) Nesting level of the ,
and instructions is 6 levels or
deeper, and the 6th level was
executed.
(4) There is no or
instruction at execution of the
or instruction.
(1) Read the error step using a
peripheral device, check contents
and correct program of the step.
(2) Reduce the number of nesting levels
of the , and
instructions to 5 or less.
134 The instruction was included in
the program and executed though no
sub program was provided.
Read the error step using a peripheral
device and delete the instruction
circuit block.
135 (1) and
instructions are not paired.
(2) There are 33 or more sets of
and
instructions.
(1) Read the error step using a
peripheral device, check contents
and correct program of the step.
(2) Reduce the number of sets of
and
instructions to 32 or less.
CJ
SCJ
CALL
CALLP
JMP
LEDA/B FCALL
LEDA/BBREAK
END
RET
CALL
NEXT
LEDA/BBREAK
FOR
CALL
CALLP
FOR
RET
NEXT
CALL
FOR
CALL
CALLP
FOR
CHG
CHG
LEDA IX
LEDAIXEND
LEDA IX
LEDAIXEND
LEDA IX
LEDAIXEND
To Next Page
Loading...
Need help?
General
