To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...What to do if the fuse broken detection occurs in Mitsubishi MELSEC Q?
If the fuse for the coincidence signal external output section has blown in your Mitsubishi Controller, it must be replaced by a qualified technician from the Service Center. Contact your branch office or distributor with a detailed description of the issue.
What to do if there is an invalid value in offset/gain setting and the error channel number cannot be identified on Mitsubishi Controller?
Perform the offset/gain setting again for all of the channels that use the user range settings. If the error occurs again, the module may be malfunctioning. Please consult your local Mitsubishi representative, explaining a detailed description of the problem.
What should I do if the value set to the intelligent function switch 5 is other than 0 in Mitsubishi MELSEC Q?
Re-set the correct parameter value in the parameter setting of GX Developer.
How do I resolve the issue of a specified digital value being outside the range on my Mitsubishi MELSEC Q Controller?
Set a value that is within the range.
How do I fix setting outside the output range on Mitsubishi Controller?
Reset to the correct parameter with GX Developer parameter setting.
What to do if more than one channel was set at the same time during offset/gain settings on Mitsubishi MELSEC Q Controller?
Set the correct value in offset/ gain setting mode (Un\G22, Un\G23).
What should I do if the value set to the G(P).OGLOAD instruction, G(P).OGSTOR instruction or save data classification setting is outside the range on Mitsubishi MELSEC Q Controller?
Set the value within the range.
What to do if the G(P).OGSTOR instruction was executed consecutively on Mitsubishi Controller?
Execute the G(P).OGSTOR instruction only once for one module. At the time of offset/gain setting, write a set value only once at one time.
How to solve scaling upper/lower limit value set outside the range of –32000 to 32000 on Mitsubishi Controller?
Correct the scaling upper/lower limit value within the range of –32000 to 32000.
General| Series | MELSEC Q Series |
|---|---|
| Type | Modular PLC |
| Programming Software | GX Works2, GX Works3 |
| Category | Programmable Logic Controller (PLC) |
| I/O Modules | Digital I/O, Analog I/O, High-Speed Counter, Positioning |
| Communication | Ethernet, CC-Link |
| Programming Languages | Ladder Logic, Structured Text, Function Block Diagram, Sequential Function Chart, Instruction List |
| Memory | Flash Memory |
| I/O Points | Up to 4096 points (expandable with additional modules) |
| Power Supply | AC or DC power supply options available, depending on the base unit and modules. |
| Mounting | DIN rail mounting |
| Operating Temperature | 0°C to 55°C |
| Storage Temperature | -25°C to 75°C |
| Humidity | 5% to 95% (non-condensing) |
| Vibration Resistance | 10 to 57 Hz, 0.075mm amplitude |
| Weight | Varies depending on the module, from a few grams to several kilograms. |
| Shock Resistance | 147 m/s² (3 times each in X, Y, Z directions) |
