L
Lisa ElliottAug 27, 2025
What causes undervoltage on Mitsubishi Amplifier?
- MMark HayesAug 27, 2025
Undervoltage in your Mitsubishi Amplifier can be due to: * Voltage drop in the control circuit power. * Voltage drop in the main circuit power.
To Next PageTo Next PageWhat causes undervoltage on Mitsubishi Amplifier?
Undervoltage in your Mitsubishi Amplifier can be due to: * Voltage drop in the control circuit power. * Voltage drop in the main circuit power.
Why is my Mitsubishi MR-J4-10A showing a servo motor overheat error?
A servo motor overheat error in your Mitsubishi Amplifier can be due to: * Abnormal temperature of servo motor 1. * Abnormal temperature of servo motor 2. * Thermistor disconnected error. * Abnormal temperature of servo motor 3. * Abnormal temperature of servo motor 4.
What causes a main circuit error in my Mitsubishi Amplifier?
A main circuit error in your Mitsubishi Amplifier can occur due to: * A ground fault detected by the hardware detection circuit. * A ground fault detected by the software detection function.
What causes an overspeed error on a Mitsubishi Amplifier?
An overspeed error on your Mitsubishi Amplifier is caused by abnormal motor speed.
General| Series | MR-J4 |
|---|---|
| Type | AC Servo Amplifier |
| Model | MR-J4-10A |
| Voltage Class | 200V |
| Position Control | Yes |
| Speed Control | Yes |
| Torque Control | Yes |
| Full-closed control | Yes |
| Communication | SSCNET III/H |
| Dynamic brake | Built-in |
| Ambient temperature | 0 to 55 °C |
| Vibration resistance | 5.9 m/s² |
| Rated output current | 0.6 A |
| Cooling Method | Natural Cooling |
| Rated Output | 0.1 kW |
| Input Voltage | 200V |
| Output Voltage | 200V |
| Control Mode | Position control, Speed control, Torque control |
| Protection Functions | Overvoltage, Undervoltage |
| Control Method | Sine wave PWM control |
| Ambient humidity | Up to 90% (No condensation) |
