Press the “ SET” switch.
The following setting display appears.
“
” (flashing)
“
” (lit)
Press the “ SET” switch for 3 seconds or more.
The air conditioning system enters the silent mode and the
display area shows the following.
“
” (lit for 1 second)
‚
“
” (lit for 1 second)
‚
“
” or “ ” (lit)
Press the or switch.
If you press the switch, “ ” is
displayed.
If you press the
switch, “ ” is dis-
played.
Select “
”.
Note:
If you press the “ RESET” switch, the remote controller
returns to the original display.
3
1
2
When the silent mode is set, the air conditioning system operates more quietly, i.e., noise from the outdoor unit is
reduced.
The system starts the silent operation at the set time and stops the silent operation after the set time has passed.
When the air conditioning system is set to operate in the silent mode, it repeats the silent operation and stopping every
day at the same time, until the silent mode is canceled.
Press the or switch.
Set the on time.
● Setting “hours”
Keep the
or switch pressed long enough to change
the “hour” display in increments/decrements of 1 hour.
Release the switch to stop changing the hours.
● Setting “minutes”
Press the
or switch briefly to increase or decrease
the displayed value by 10 minutes.
“
” and “ ” are dis-
played alternately.
4
● After the silent mode is set, the following is displayed for 3 seconds at the set time and the remote controller returns to the
original display.
At the on time: “
”
At the off time: “
”
● If you press the “
” switch while in the Silent setting mode, the remote controller exits from the Silent setting mode and
returns to the original display. Please be aware that settings that have not been committed become invalid.
NOTE
SILENT MODE
HOW TO OPERATE IN SILENT MODE
■ Setting Silent Mode
Press the or switch.
Select an off time.
If you press the
switch, the set number of hours in-
creases in increments of 2 hours, and the display changes in
the order of “
”, “ ”, etc., to “ ” and then
“
”.
If you press the
switch, the set number of hours de-
creases in decrements of 2 hours.
“
” and “ ” are displayed
alternately.
Note: If you press the “
RESET” switch, the remote
controller will return to one screen earlier and display
“
”.
Press the “ SET” switch.
The on time is committed and the following display appears.
“
” (flashing)
“
” (lit for 2 seconds)
‚
“
” (flashing)
“
” (lit)
6
5
Press the “ SET” switch.
The settings are committed and displayed.
“SET COMPLETE” is displayed and the silent mode setting is
finished.
The display of the settings is turned off and the remote
controller returns to the original display.
7
13
To Next Page
Loading...
Need help?
General
