Press the “ SET” switch.
The remote controller goes into the timer operation cancella-
tion mode.
Press the “ TIMER” switch.
The remote controller goes into the timer mode.
The “current day of the week” and “current time” are dis-
played and the subsequent procedures are automatically
displayed in the following order.
“ ” ‡ “ ” ‡ “ ”
Press the switch five times.
“ ”
‚
“
” (first press)
‚
“
” (second press)
‚
“
” (third press)
‚
“
” (fourth press)
‚
“
” (fifth press)
3
1
2
TIMER CANCELLATION MODE
● If you press the “ ” switch while in the timer setting mode, the remote controller exits from the timer mode
and returns to the original display.
● If you do not press any switches for 60 seconds after entering the timer mode, the remote controller automatically exits from the
timer mode and returns to the original display.
NOTE
Press the or switch.
Select the timer mode you want to cancel.
If you press the
switch, the display of the following timer
modes is switched in the downward direction.
“
”
·
‚
“
”
·
‚
“
”
·
‚
“
” (for canceling all days of the week)
If you press the
switch, the display of the timer modes is
switched in the upward direction.
4
Press the “ SET” switch.
The settings of the selected timer mode
are displayed as shown below.
(However, if no setting has been made,
there will be no change from the
display in step 4 even if the set switch
is pressed.)
<Display example where
“
” was selected>
If you stop canceling, press the
“
RESET” switch to return to the
“
” display (step 4).
5
If “ ”, “ ” or
“
” was selected
If “
” was selected.
Perform the following operation to cancel settings for
all the days of the week.
See “Canceling Weekly Timer Mode Settings“ on page
11 to cancel settings for each day of the week.
Press the “ SET” switch.
The timer display area turns off, the
message “
” is
displayed for 2 seconds, and
“
” is displayed again
(step 4).
Repeat steps 4 to 6 to continue
canceling other timer mode settings.
6
Press the “ SET” switch.
The following is displayed.
(However, if no setting has been made,
there will be no change from the
display in step 4 even if the set switch
is pressed.)
If you stop canceling, press the
“
RESET” switch to return to the
“
” display (step 4).
5
Press the “ SET” switch.
The day display area turns off,
“
” is displayed for
two 2 seconds, and
“
” is displayed again
(step 4).
With this operation, settings for all the
days of the week are canceled.
6
Press the “ ” switch once.
This completely ends the timer cancel
procedure.
● If you press the “ ” switch while in the timer setting mode, the remote controller exits from the timer mode
and returns to the original display. Please be aware that settings that have not been committed become invalid.
● If you do not press any switches for 60 seconds after entering the timer mode, the remote controller automatically exits from the
timer mode and returns to the original display.
NOTE
12
To Next Page
Loading...
Need help?
General
