NOTE
l
On rare occasions, the value displayed for
the driving range may change if you are
parked on an extremely steep incline. This is
due to the movement of fuel in the tank and
does not indicate a malfunction.
l
The display setting can be changed to the
preferred units (km or miles).
Refer to “ Changing the function settings” ”
on page 5-14.
Average fuel consumption dis-
play
E00531200020
This displays the average fuel consumption
from the last reset to the present time.
There are the following 2 mode settings.
Refer to “Changing the reset mode for aver-
age fuel consumption and average speed” on
page 5-15
For information on how to change the aver-
age fuel consumption display setting, refer to
“ Changing the function settings ” on page
5-14.
NOTE
l
The average speed display and the average
fuel consumption display can be reset indi-
vidually for the auto reset mode and manual
reset mode.
l
“---” is displayed when the average fuel con-
sumption cannot be measured.
l
The initial (default) setting is “Auto reset
mode”.
l
The average fuel consumption depends on
the driving condition (road condition, driv-
ing behavior, etc.). The displayed fuel con-
sumption may vary from the actual fuel con-
sumption. Treat the fuel consumption dis-
played as just a rough guideline.
l
The memory of the auto reset mode or man-
ual reset mode for the average fuel con-
sumption display is erased if the battery is
disconnected.
l
The display setting can be changed to the
preferred units {km/L, mpg (US), mpg (UK)
or L/100 km}.
Refer to “Changing the function settings” on
page 5-14.
Average speed display
E00533700029
This displays the average speed from the last
reset to the present time.
There are the following 2 mode settings.
Refer to “Changing the reset mode for aver-
age fuel consumption and average speed” on
page 5-15.
For the method for changing the average
speed display setting, refer to “Changing the
function settings” on page 5-14.
NOTE
l
The average speed display can be reset sepa-
rately for the auto reset mode and for the
manual reset mode.
l
“---” is displayed when the average speed
cannot be measured.
l
The initial (default) setting is “Auto reset
mode”.
l
The display setting can be changed to the
preferred units (km/h or mph).
Refer to “Changing the function settings” on
page 5-14.
l
The memory of the auto reset mode or man-
ual reset mode for the average speed display
is erased if the battery is disconnected.
Momentary fuel consumption
display
E00533601067
While driving, this displays the momentary
fuel consumption, using a bar graph.
Multi information display - Type 1
5-12
OGFE16E1
Instruments and controls
5
To Next Page
Loading...
Need help?
General
