Refer to “Changing the display lan-
guage” on page 5-17.
Refer to “Changing the language cooper-
ative control” on page 5-17.
Refer to “Operation sound setting” on
page 5-18.
Refer to “Changing the time until
“REST REMINDER” is displayed” on
page 5-18.
Refer to “Changing the turn-signal
sound” on page 5-19.
Refer to “Changing the momentary fuel
consumption display” on page 5-19.
Refer to “Reset of low tyre pressure
warning threshold” on page 6-105.
Refer to “Tyre ID set change” on page
6-106.
Refer to “Returning to the factory set-
tings” on page 5-19.
NOTE
l
If the battery is disconnected, these function
settings are reset from memory and automat-
ically return to the factory settings (except
the low tyre pressure warning threshold and
tyre ID set).
Changing the reset mode for
average fuel consumption and
average speed
E00522900962
The mode conditions for the average fuel
consumption and average speed display can
be switched between “Auto reset” and “Man-
ual reset”.
1. Press and hold the multi information dis-
play switch for about 2 seconds or more
to switch from the setting mode screen
to the menu screen.
Refer to “Information display” on page
5-21.
2. Lightly press the multi information dis-
play switch to select “AVG (average
fuel consumption and average speed set-
ting)”.
3. Press and hold the multi information dis-
play switch for about 2 seconds or more
to switch from A/1 (Auto reset mode) to
M/2/P (Manual reset mode), or from
M/2/P to A/1.
The setting is changed to the selected
mode condition.
Manual reset mode
l
When the average fuel consumption and
average speed are being displayed, if
you hold down the multi information
display switch, the average fuel con-
sumption and average speed displayed at
that time are reset.
l
When the following operation is per-
formed, the mode setting is automatical-
ly switched from manual to auto.
[Except for vehicles equipped with key-
less operation system]
Turn the ignition switch from the
“ACC” or “LOCK” position to the “ON”
position.
[For vehicles equipped with keyless op-
eration system]
Change the operation mode from ACC
or OFF to ON.
Switching to auto occurs automatically.
If switching to manual mode is done,
however, the data from the last reset is
displayed.
Multi information display - Type 1
5-15
OGFE16E1
Instruments and controls
5
To Next Page
Loading...
Need help?
General
