1. When you lightly press the multi infor-
mation display switch a few times, the
information display switches to the serv-
ice reminder display.
2. Press and hold the multi information dis-
play switch for about 2 seconds or more
to make the spanner mark start flashing.
(If there is no operation for about 10 sec-
onds with flashing, the display will re-
vert to its original indication.)
3. Lightly press the multi information dis-
play switch while the icon is flashing to
change the display from “---” to
“cLEAr”. After this, the time until the
next periodic inspection will be dis-
played.
CAUTION
l
The customer is responsible for making sure
that periodic inspection and maintenance are
performed. Inspections and maintenance
must be performed to prevent accidents and
malfunctions.
NOTE
l
“---”display cannot be reset when the igni-
tion switch or the operation mode is in ON.
NOTE
l
When “---” is displayed, after a certain dis-
tance and a certain period of time, the dis-
play is reset and the time until the next peri-
odic inspection is displayed.
l
If you accidentally reset the display, consult
a MITSUBISHI MOTORS Authorized Serv-
ice Point.
Changing the function settings
E00522700595
The “Average fuel consumption reset mode”,
“Fuel consumption unit” and “Temperature
unit” setting can be modified as desired,
when the ignition switch or the operation
mode is ON.
CAUTION
l
The driver should not operate the display
while the vehicle is in motion.
l
When operating the system, stop the vehicle
in a safe area.
Changing the reset mode for
average fuel consumption
E00522900975
The mode conditions for the average fuel
consumption display can be switched be-
tween “Auto reset” and “Manual reset”.
Multi information display - Type 2
5-26
OGFE16E1
Instruments and controls
5
To Next Page
Loading...
Need help?
General
