Mitsubishi Outlander 2015 - Page 137

1. When you lightly press the multi infor-
mation display switch a few times, the
information display switches to the driv-
ing range display.
Refer to “Information display” on page
5-21.
2. Each time you press the multi informa-
tion display switch for 2 seconds or
more on driving range display, you can
switch reset mode for average fuel con-
sumption.
(A: Auto reset mode, B: Manual reset
mode)
Auto reset mode Manual reset mode
Manual reset mode
l
When the average fuel consumption is
being displayed, if you hold down the
multi-information meter switch, the
average fuel consumption displayed at
that time is reset.
l
When the following operation is per-
formed, the mode setting is automatical-
ly switched from manual to auto.
[Except for vehicles equipped with key-
less operation system]
Turn the ignition switch from the
“ACC” or “LOCK” position to the “ON”
position.
[For vehicles equipped with keyless op-
eration system]
Change the operation mode from ACC
or OFF to ON.
Switching to auto occurs automatically.
If switching to manual mode is done,
however, the data from the last reset is
displayed.
Auto reset mode
l
When the average fuel consumption is
being displayed, if you hold down the
multi information display switch, the
average fuel consumption displayed at
that time are reset.
l
When the engine switch or the operation
mode is in the following conditions, the
average fuel consumption display is au-
tomatically reset.
[Except for vehicles equipped with key-
less operation system]
The ignition switch is in the “ACC” or
“LOCK” position for about 4 hours or
longer.
[For vehicles equipped with keyless op-
eration system]
The operation mode is in ACC or OFF
for about 4 hours or longer.
NOTE
l
The average fuel consumption display can
be reset separately for the auto reset mode
and for the manual reset mode.
l
The memory of the auto reset mode or man-
ual reset mode for the average fuel con-
sumption display is erased if the battery is
disconnected.
l
The initial (default) setting is “Auto reset
mode”.
Changing the fuel consumption
display unit
E00523001794
The display unit for fuel consumption can be
switched. The distance and amount units are
also switched to match the selected fuel con-
sumption unit.
Multi information display - Type 2
5-27
OGFE16E1
Instruments and controls
5