While depressing the brake pedal,
move the selector lever through the
gate.
Move the selector lever through the
gate.
WARNING
l
Always depress the brake pedal when
shifting the selector lever into a gear from
the “P” (PARK) or “N” (NEUTRAL) po-
sition.
Never put your foot on the accelerator
pedal while shifting the selector lever
from the “P” (PARK) or “N” (NEU-
TRAL) position.
NOTE
l
To avoid erroneous operation, move the se-
lector lever firmly into each position and
briefly hold it there. Always check the posi-
tion shown by the selector lever position dis-
play after moving the selector lever.
l
If the brake pedal is not depressed and held,
the shift-lock device activates to prevent the
selector lever from being moved from the
“P” (PARK) position.
When the selector lever cannot
be shifted from the “P” (PARK)
position
E00629101150
When the selector lever cannot be shifted
from the “P” (PARK) position to another po-
sition while the brake pedal is pressed and
held down with the ignition switch at the
“ON” position or the operation mode in ON,
the battery may be flat or the shiftlock mech-
anism may be malfunctioning. Immediately
have your vehicle checked by a
MITSUBISHI MOTORS Authorized Service
Point.
If you need to move the vehicle, shift the se-
lector lever as follows.
For LHD vehicles
1. Make sure the parking brake is applied.
2. Stop the engine if it is running.
3. Insert a straight blade (or minus) screw-
driver with a cloth over its tip into notch
(A) or the cover. Pry gently as shown to
remove the cover.
4. Depress the brake pedal with the right
foot.
Automatic transmission INVECS-II 6A/T (Intelligent & Innovative Vehicle Electronic Control System II)*
6-37
OGFE16E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
