5. Insert a straight blade (or minus) screw-
driver in the shiftlock release hole (B).
Shift the selector lever to the “N” (NEU-
TRAL) position while pressing the
straight blade (or minus) screwdriver
down.
For RHD vehicles
1. Make sure the parking brake is applied.
2. Stop the engine if it is running.
3. Depress the brake pedal with the right
foot.
4. Insert a straight blade (or minus) screw-
driver in the shiftlock release hole (A).
Shift the selector lever to the “N” (NEU-
TRAL) position while pressing the
straight blade (or minus) screwdriver
down.
Selector lever position display
E00603501925
When the ignition switch is turned to the
“ON” position or the operation mode is put in
ON, the position of the selector lever is indi-
cated in the multi information display.
Selector lever positions
E00603801830
“P” PARK
This position locks the transmission to pre-
vent the vehicle from moving. The engine
can be started in this position.
“R” REVERSE
This position is to back up.
Automatic transmission INVECS-II 6A/T (Intelligent & Innovative Vehicle Electronic Control System II)*
6-38
OGFE16E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
