CAUTION
l
If the drive mode indicator (4WD) is blink-
ing, a problem has occurred with the S-
AWC system and the safety device has acti-
vated.
The warning display is also displayed in the
information screen in the multi information
display.
Warning display (colour liquid crystal dis-
play)
Have an inspection made by a MITSUBISHI
MOTORS Authorized Service Point.
l
Be sure to use tyres that are the same speci-
fied size, type, and brand, and have no dif-
ference in the amount of wear for all 4
wheels. Otherwise, the S-AWC system may
not work properly, and 4WD system warn-
ing (overheating or service required) may be
indicated.
S-AWC operation display
E00623101233
The S-AWC operation status can be dis-
played on the information screen in the multi
information display.
To display the status, press the multi infor-
mation display switch to change the informa-
tion screen.
Refer to “Information screen (when the igni-
tion switch or the operation mode is ON)” on
page 5-06
Display example
The S-AWC operation status is displayed.
Yaw control function display
The amount of the yaw moment is displayed
as a bar graph.
A,D- Clockwise yaw moment about the
vehicle’s center of gravity
B,C- Anticlockwise yaw moment about
the vehicle’s center of gravity
Differential limiting function display
The strength of the differential limiting oper-
ation (between front-rear wheels and between
left-right wheels) is displayed in section E of
the meter as a bar graph.
WARNING
l
Always concentrate on your driving first.
Keep your eyes and mind on the road.
Distractions while driving can lead to an
accident.
When the ECO mode switch is
ON
E00636501042
While the drive mode is in the “NORMAL”
position, if the ECO mode switch is switched
ON, the drive mode will be changed to
“AWC ECO” mode.
If the ECO mode switch is switched OFF, the
drive mode will be returned to “NORMAL”
mode.
Refer to “ECO mode switch” on page 5-62
S-AWC (Super All Wheel Control)*
6-56
OGFE16E1
Starting and driving
6