How to operate LDW
E00635801035
The indication on the information screen of
the multi information display changes as fol-
lows depending on the state of the system.
Turning on the system
When you set the ignition switch or operation
mode to “ON”, the “LDW” indicator appears
on the information screen of the multi infor-
mation display, showing that the system is
placed in the ‘ON state’.
Turning off the system
When you press the LDW switch, the
“LDW” indicator on the information screen
of the multi information display goes out,
showing that the system is placed in the ‘OFF
state’. Press the switch again, the system re-
turns to “ON”.
NOTE
l
When you set the ignition switch or opera-
tion mode to “OFF” with the system
“OFF,”the system will be restored “ON.”
(“LDW 1”mode)
You can also select the “LDW 2” mode
which always turns the LDW system in
‘OFF state’.
1
.
Press the LDW switch, and the sys-
tem is placed in the ‘OFF state’.
2
.
Press and hold the LDW switch for
more than approximately 10 seconds.
The “LDW 2” indicator appears on
the multi information display.
3
.
Press the LDW switch, and the
“LDW” indicator on the top-right of
the multi information display goes
out.
To return to the “LDW 1” mode, put the sys-
tem in ‘OFF state’, press and hold the LDW
switch for more than approximately 10 sec-
onds. The “LDW 1” indicator appears on the
multi information display.
Standby state
In the standby mode, the system is capable of
recognizing the lane in which your vehicle is
positioned and issuing audible warning when
your vehicle goes out of the lane.
The system automatically shifts from the
‘ON state’ to the ‘standby state’ if all of the
following conditions are simultaneously met.
Lane Departure Warning (LDW)*
6-98
OGFE16E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
