The “LDW” indicator in the information dis-
play changes to indicator (green).
l
The vehicle speed is approximately
65 km/h (40 mph) or higher.
l
The turn-signal lever is not operated.
l
The hazard lamp is not activated.
l
The brake pedal is not depressed.
l
Environmental conditions are adequate
for the system to recognize the lane
markings on both sides.
l
The system has been placed in the ‘ON
state’.
NOTE
l
The system stays in the “ON” state for about
7 seconds after the hazard lamp has stopped
flashing or the turn-signal lever has returned
to the home position.
Lane departure warning
E00638600037
A buzzer sounds intermittently and indication
of “LANE DEPARTURE” appears in the in-
formation display, indicator flashing in
amber when your vehicle is about to leave or
has left the lane in the standby mode.
NOTE
l
If warning continues for about 3 seconds or
more, the system switches to the standby
mode before the warning stops.
System problem warning
E00635901049
If a problem occurs with the system, a visual
warning specific to the type of the problem is
given together with an audible alarm.
Too hot LDW camera
E00638700038
The alarm shown below is displayed if the
system becomes temporarily unable due to
too high a temperature of the LDW camera.
If the camera cools down below the predeter-
mined temperature, the system automatically
recovers the normal state.
NOTE
l
The warning message can be cleared tempo-
rarily by setting the LDW switch to “OFF.”
LDW deactivation due to fault
E00638800039
The alarm shown below is displayed if LDW
becomes to a non-initialized state due to a
fault.
If this happens, please contact a
MITSUBISHI MOTORS Authorized Service
Point for inspection of the system.
Lane Departure Warning (LDW)*
6-99
OGFE16E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
