Each time the door and tailgate unlock func-
tion is set, a chime will sound to tell you the
condition of the door and tailgate unlock
function.
Number of
chimes
Condition
One chime
All doors and the tailgate un-
lock
Two chimes Driver’s door unlock only
1. Turn the ignition switch to the “LOCK”
position and then remove the key (vehi-
cles with keyless entry system), or put
the operation mode in OFF (vehicles
with keyless operation system).
2. Place the combination headlamps and
dipper switch in the “OFF” position, and
leave the driver’s door open.
3. Press the LOCK switch (1) for 4 to 10
seconds and press the UNLOCK switch
(2) during this time.
4. Release in sequence the LOCK and UN-
LOCK switches within 10 seconds of
pressing the LOCK switch in step 3.
NOTE
l
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the
adjustment. Refer to the separate owner’s
manual for details.
Procedure for replacing the re-
mote control switch battery
E00309501445
Before replacing the battery, remove static
electricity from your body by touching a met-
al grounded object.
WARNING
l
Danger of explosion if battery is incor-
rectly replaced. Replace only with the
same battery or an equivalent type.
CAUTION
l
When the remote control switch case is
opened, be careful to keep water, dust, etc.
out. Also, do not touch the internal compo-
nents.
NOTE
l
You may purchase a replacement battery at
an electric appliance store.
NOTE
l
A MITSUBISHI MOTORS Authorized
Service Point can replace the battery for you
if you prefer.
[Keyless entry key]
1. Remove the screw (A) from the remote
control switch.
2. With the MITSUBISHI mark facing
you, insert the cloth-covered tip of a
straight blade (or minus) screwdriver in-
Keyless entry system*
3-06
OGFE16E1
Locking and unlocking
3
To Next Page
Loading...
