to the notch in the remote control switch
case and use it to open the case.
NOTE
l
Be sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the remote control switch case, the
switches may come out.
3. Remove the remote control transmitter
from the remote control switch case.
Then, open the remote control transmit-
ter using the method described in step 2.
4. Remove the old battery.
5. Install a new battery with the + side (B)
down.
Coin type battery
CR1616
- side
+ side
6. Close the remote control transmitter
firmly.
7. Place the remote control transmitter in
the remote control switch case, then se-
curely close the remote control switch
case.
8. Attach the screw (A) removed in step 1.
9. Check the keyless entry system to see
that it works.
[Keyless operation key]
1. With the MITSUBISHI mark facing
you, insert the cloth-covered tip of a
straight blade (or minus) screwdriver in-
to the notch in the remote control switch
case and use it to open the case.
NOTE
l
Be sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the remote control switch case, the
transmitter may come out.
Keyless entry system*
3-07
OGFE16E1
Locking and unlocking
3
To Next Page
Loading...
Need help?
General
