l
When the ignition switch is switched from
“ACC” or “LOCK” to “ON”, the mode set-
ting is automatically switched from manual
to auto.
Although the mode setting is automatically
switched to the auto reset mode, if you
switch the mode setting to the manual reset
mode, the average fuel consumption from the
last time the display is reset will be displayed.
Auto reset mode
l
When the average fuel consumption is being
displayed, if you hold down the multi-infor-
mation meter switch, the average fuel con-
sumption displayed at that time is reset.
l
If the ignition switch is at “ACC” or
“LOCK” for about 4 hours or longer, the aver-
age fuel consumption display is automatical-
ly reset.
NOTE
l
The average speed display and the average
fuel consumption display can be reset individ-
ually for the auto reset mode and manual re-
set mode.
l
“---” is displayed when the average fuel con-
sumption cannot be measured.
l
The initial (default) setting is “Auto reset
mode”.
l
The average fuel consumption depends on
the driving condition (road condition, driving
behavior, etc.). The displayed fuel consump-
tion may vary from the actual fuel consump-
tion. Treat the fuel consumption displayed as
just a rough guideline.
l
The memory of the auto reset mode or man-
ual reset mode for the average fuel consump-
tion display is erased if the battery is discon-
nected.
l
The display setting can be changed to the pre-
ferred units {km/L, mpg (US), mpg (UK) or
L/100 km}.
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on page
3-17.
Momentary fuel consumption display
E00521800560
While driving, this displays the momentary fuel con-
sumption, using a bar graph.
When the momentary fuel consumption surpasses
the average fuel consumption, the momentary fuel
consumption is displayed with a green bar graph.
(Type 2)
Be conscious that when maintaining the momenta-
ry fuel consumption above the average fuel con-
sumption, driving with better fuel consumption can
be possible.
NOTE
l
When the momentary fuel consumption can-
not be measured, the bar graph is not dis-
played.
l
The display setting can be changed to the pre-
ferred units {km/L, mpg (US), mpg (UK) or
L/100 km}.
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on page
3-17.
l
It is possible to cancel the green bar graph.
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on page
3-17.
Function setting screen
E00521900138
The “Display language”, “Temperature
unit”, “Fuel consumption unit”, and
“Average fuel consumption and speed re-
set method” etc. settings can be modi-
fied as desired.
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on
page 3-17.
Instruments and controls
3-13
3
To Next Page
Loading...
Need help?
General
