3. Lightly press the multi-information meter
switch while the icon is flashing to change
the display from “---” to “CLEAR”. After
this, the time until the next periodic inspec-
tion will be displayed.
CAUTION
l
The customer is responsible for making
sure that periodic inspection and mainte-
nance are performed. Inspections and
maintenance must be performed to pre-
vent accidents and malfunctions.
NOTE
l
“---” display cannot be reset when the igni-
tion switch is “ON”.
l
When “---” is displayed, after a certain dis-
tance and a certain period of time, the dis-
play is reset and the time until the next peri-
odic inspection is displayed.
l
If you accidentally reset the display, we rec-
ommend you to consult a MITSUBISHI
MOTORS Authorized Service Point.
Door ajar warning display screen
(when the ignition switch is “ON”)
E00522600451
Type 1
Type 2
If any of the doors or the tailgate is not completely
closed, this displays the open door or tailgate.
If the vehicle speed exceeds approximately 8 km/h
(5 mph) while a door is ajar, a buzzer sounds 4
times. This notifies the driver that a door is ajar.
CAUTION
l
Before moving your vehicle, check that
the warning lamp is OFF.
Changing the function settings (when
the ignition switch is “ON”)
E00522700436
1. Stop the vehicle in a safe place.
Firmly apply the parking brake and put the
gearshift lever into the “N” (Neutral) posi-
tion (M/T), gearshift lever into the “P”
(Park) position (Twin Clutch SST) or the se-
lector lever into the “P” (PARK) position
(A/T or CVT).
2. Lightly press the multi-information meter
switch a few times to switch the information
screen to the function setting screen.
Refer to “Information screen (when the igni-
tion switch is “ON”)” on page 3-10.
Instruments and controls
3-17
3
To Next Page
Loading...
Need help?
General
