When the cause of the warning display
is eliminated, the mark goes out auto-
matically.
NOTE
l
When the mark is displayed,
the warning display screen can be
redisplayed on the information
screen.
Refer to “Information screen
(when the ignition switch is
“OFF“)” on page 3-06.
Refer to “Information screen
(when the ignition switch is
“ON”)” on page 3-10.
Active Stability Control (ASC)
OFF display screen*
E00521000487
This is displayed when the Active Stabil-
ity Control (ASC) is turned off with the
ASC OFF switch.
If there is a fault with the ASC, the ASC
OFF display is shown.
Refer to ““ASC OFF” switch” on page
4-58.
Information screen (when the ignition
switch is “ON”)
E00521100651
Each time you lightly press the multi-information
meter switch, the display screen switches in the fol-
lowing order.
Type 1
Type 2
When there is no warning display
When there is no warning display
When there is a
warning display
When there is a
warning display
1-
Odometer (Type 1)/Tripmeter
2-
Odometer (Type 1)/Tripmeter
3- Service reminder
4- Engine coolant temperature display (Type 1)
5- Driving range display (Type 1)
6- Average speed display, average fuel consump-
tion display, momentary fuel consumption
display (Type 1)
7- Driving range display, momentary fuel con-
sumption display (Type 2)
8- Average fuel consumption display, momenta-
ry fuel consumption display (Type 2)
9. Average speed display, momentary fuel con-
sumption display (Type 2)
10. Function setting screen
11. Redisplay of a warning display screen
NOTE
l
While driving, even if you operate the multi-
information meter switch, the function set-
ting screen is not displayed. Always stop the
vehicle in a safe place before operating.
Refer to “Changing the function settings
(when the ignition switch is “ON”)” on page
3-17.
l
When there is information to be announced,
such as a system fault, the buzzer sounds and
the screen display is switched.
Refer to “Interrupt display screen (when the
ignition switch is “ON”)” on page 3-14.
Instruments and controls
3-10
3