Brake pedal
While driving at the set speed, use the brake pedal,
which disengages the cruise control, then press the
“COAST SET” switch (B) and release the switch
momentarily to set a new desired cruising speed.
To temporarily increase or decrease
the speed
E00609600149
To temporarily increase the speed
Depress the accelerator pedal as you would normal-
ly. When you release the pedal, you will return to
your set speed.
NOTE
l
In some driving conditions, the set speed driv-
ing may be deactivated. If this happens, refer
to “To activate” on page 4-61 and repeat the
speed setting procedure.
To temporarily decrease the speed
Depress the brake pedal to decrease the speed. To
return to the previously set speed, press the “ACC
RES” switch (C).
Refer to “To resume the set speed” on page 4-64.
To deactivate
E00609701046
The set speed driving can be deactivated as follows:
l
Press the “ON OFF” switch (A) (Cruise con-
trol will be turned off)
l
Press the “CANCEL” switch (D).
l
Depress the brake pedal.
The set speed driving is deactivated automatically
in any of the following ways.
Starting and driving
4-63
4
To Next Page
Loading...
Need help?
General
