l
When you depress the clutch pedal (on vehi-
cles with M/T).
l
When your speed slows to about 15 km/h
(9 mph) or more below the set speed because
of a hill, etc. (except 2000 models)
l
When your speed slows to about 40 km/h
(25 mph) or less.
l
When the Active Stability Control (ASC)
starts operating. (if so equipped)
Refer to “Active stability control (ASC)” on
page 4-58.
l
When you shift the 2
nd
gear in manual shift-
ing (on vehicles equipped with Twin clutch
SST).
WARNING
l
On vehicles equipped with A/T, CVT or
Twin Clutch SST, although the set speed
driving will be deactivated when shifting
to the “N” (NEUTRAL) position, never
move the selector lever (A/T or CVT) or
the gearshift lever (Twin Clutch SST) to
the “N” (NEUTRAL) position while driv-
ing.
You would have no engine braking and
could cause a serious accident.
Also, the set speed driving may be deactivated as
follows:
l
When the engine speed rises and approaches
the tachometer's red zone (the red-coloured
part of the tachometer dial).
CAUTION
l
When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the “ON-OFF” switch to turn off
the cruise control and have your vehicle
inspected by a MITSUBISHI MOTORS
Authorized Service Point.
To resume the set speed
E00609800457
If the set speed driving is deactivated by the condi-
tion described in “To deactivate” on page 4-63,
you can resume the previously set speed by press-
ing the “ACC RES” switch (C) while driving at a
speed of about 40 km/h (25 mph) or higher.
Under either of the following conditions, however,
using the switch does not allow you to resume the
previously set speed.
In these situations, repeat the speed setting proce-
dure:
l
The “ON OFF” switch is pressed.
l
The ignition switch is turned OFF.
l
“CRUISE” indication lamp is turned OFF.
Starting and driving
4-64
4
To Next Page
Loading...
Need help?
General
