2. Turn the cap (B) anticlockwise to remove it.
*: Front of the vehicle
3. Turn the bulb (C) anticlockwise to remove it.
*: Front of the vehicle
4. While holding down the tab (D), pull out the
bulb (E).
5. To install the bulb, perform the removal
steps in reverse.
CAUTION
l
Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the bending
lamps (Adaptive Front lighting System
(AFS)) are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
Position lamps
E01003700976
1. When replacing the bulb on the left side of
the vehicle in the case of 2200 models and
3000 models, remove the bolt (A) holding
down the relay box and move the relay box
towards the rear of the vehicle.
*: Front of the vehicle
Maintenance
8-28
8
To Next Page
Loading...
Need help?
General
