l
On vehicles with Twin Clutch SST, when the
engine has not been started within about 5 sec-
onds after the diesel preheat indication lamp
went out, return the ignition switch to the
“LOCK” position. Then, turn the switch to
the “ON” position to preheat the engine again.
l
When the engine is warm, the diesel preheat
indication lamp does not come on even if the
ignition switch is placed in the “ON” position.
Start the engine by turning the ignition
switch right to the “START” position.
7. Turn the ignition switch to the “START” po-
sition without depressing the accelerator ped-
al, and release it when the engine starts.
NOTE
l
Minor noises may be heard on engine start-
up. These will disappear as the engine warms
up.
Using the MIVEC engine
The MIVEC engine automatically switches its in-
take-valve control between a low-speed mode and
a high-speed mode in accordance with driving con-
ditions for maximum engine performance.
NOTE
l
To protect the engine, the high-speed mode
may not be selected while the engine coolant
temperature is low.
To operate without using the keyless
operation function
E00306000019
Emergency key
E00307200353
The emergency key is built into the keyless opera-
tion key. If the keyless operation function cannot
be used, for example because the keyless operation
key battery has worn out or the vehicle battery is
flat, you can lock and unlock the driver’s door and
start the engine with the emergency key. To use the
emergency key (A), unlock the lock knob (B) and
remove it from the keyless operation key (C).
NOTE
l
Only use the emergency key for emergen-
cies. If the keyless operation key battery
wears out, replace it as quickly as possible so
that you can use the keyless operation key.
l
After using the emergency key, always re-
turn it into the keyless operation key.
l
The glove box can only be locked or un-
locked with the emergency key. When leav-
ing your key at a hotel reception or lending
your vehicle to someone else, take out the
emergency key as necessary and hand over
only the keyless operation key.
Locking and unlocking the driver’s door
Turning the emergency key in the forward direc-
tion locks the door, and turning it in the rear direc-
tion unlocks the door. Also refer to “Locking and
unlocking: Doors” on page 1-26.
1- Lock
2- Unlock
Electronic immobilizer (Anti-theft starting system)
E00307300400
The electronic immobilizer has been designed to sig-
nificantly reduce the possibility of vehicle theft.
The purpose of the system is to immobilize the ve-
hicle if an invalid start is attempted. A valid start
attempt can only be achieved (subject to certain con-
ditions) using a keyless operation system and emer-
gency key “registered” to the immobilizer system.
Locking and unlocking
1-18
1
To Next Page
Loading...
Need help?
General
