Mitsubishi P91DW User Manual

8
44
44
4 Close the door.
INSTALLATION OF PAPER
5
Moisture, fingerprints or dust on the
paper surface may cause a noise at
printing or deterioration in print
quality. Set the paper in the following
procedure to prevent adhesion of
fingerprint or dust on the paper
surface.
11
11
1 Open the door.
• Switch the lever
located on the
left side to the
“OPEN” position.
The door opens.
22
22
2 Load the paper roll.
•Place the paper roll
in the printer.
Note: The printing surface is the outside.
Place the paper with the thermo-
sensitive side (printing side) up.
When the paper roll is placed
inversely, images can not be printed.
printing side
INCORRECT CORRECT
33
33
3 Pull out the paper end.
• Pull out the first 15-
20cm (6 in. - 9 in.) of
the paper to remove
any slack in the roll.
• Cut the paper end with the cutter just like
tearing off the paper.
cutter
OPEN
55
55
5 Cut the paper end.

Mitsubishi P91DW Specifications

General

Brand	Mitsubishi
Model	P91DW
Category	Printer
Language	English