Chapter 4 Fuel and exhaust systems
14.178 When removing the needle seat, . . .
14.17b . . . grasp the seat at area A, not in area B
14.18 Remove the main jets
14.19a To remove the pilot jet, remove the retainer, . . I
14.19b . . . then carefully pull out the jet with 14.20 Remove the iwo lock screws and remove the
needle-nose pliers
choke pinion assembly
17 Unscrew the retainer and remove the needle seat with a pair of pliers 20 Remove the two lock screws and remove the choke pinion assembjy
(see illustration). Caution: When removing the need/e seat, clamp area
(see illustration).
A with pliers, not area 6 (see illustration).
21 Remove the checkweight and ball, and the steel ball of the anti-over-
18 Using a screwdriver with the right size tip, remove the main jets from fill device (see illustration).
the jet blocks (see illustration). 22 Remove the accelerator pump mounting screws and remove the
19 Remove the pilot jet retainer and pull out the secondary pilot jet with
pump cover link assembly, diaphragm, spring, body and gasket from the
pliers (see illustrations). main body (see illustration).
To Next Page
Loading...
