.
Chapter
7
Part C Transfer case
Contents
4WD indicator light switches-removal and installation . . . . . . . 3
General information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . _ . . . . 1
Oil seal replacement . . . . . . . . . . . . _ _ . . . . . . . . . . . See Chapter 7A
Shift lever - removal and installation . . . . . . . . _ _ _ . . . . . . . . . . . _ 2
Transfer case lubricant change . _ . . . . . _ _ _ _ _ _. _ . . See Chapter I
Transfer case lubricant level check . . . . . . . _ .‘. . . . . _ See Chapter 1
Transfer case overhaul -general information . . . . . . . . . . . . _ 4
Transmission mount-check and replacement . . . . _ See Chapter 7A
-
Specifications
Torque specifications
4WD indicator light switch . . . . . . . . . . . . . . , . . _ . . _ _ _ _ _ _ . _ . . _
Transfer case-to-transmission nuts and bolts . . . . . . . . . . . . . . . .
Ft-lbs
22
22
1.
however, remove and install the transmission/transfer case yourself and
General information
save the expense, even if the repair work is done by a specialist.
Four-wheel drive models are equipped with a transfer case mounted
on the transmission housing. Drive is passed through the transmission
and transfer case to the front and rear axles by the driveshafts.
2
Shift lever - removal and installation
On these models the transfer case is combined with the transmission
Refer to illustrations 2. la and 2. lb
to form one unit. The transfer case can’t be removed without first removing The procedure for removing the transfer case shift lever is essentially
the transmission from the vehicle. Because of the special tools and tech- the same as for removing
the
manual transmission shift lever (see
illus-
niques required, disassembly and overhaul of the transfer case should be
trations).
Refer to Chapter 7 Part A, Section 3, and follow the procedure
left to a dealer service department or properly equipped shop. You can,
outlined there.
To Next Page
Loading...
