Chapter 2 Part B 2.OL and 2.4L four-cylinder engines
2B-5
5.6 Check the contact faces and adjusting screw tips (arrows)
Cap number (none on front and rear)
Timing belt side
I
Rocker shaft
right
C D
c D
5.6a Rocker arms marked A or B belong on the intake side while
rockers marked C or D belong on the exhaust side
5.6~ On 2.4L engines, align the dimples offset to the
notches on the bearing cap
6 Valve springs, retainers and seals-replacement
Refer to illustrations 6.7 and 6.2
Note: The jet valve is mounted directly beside each intake valve. Refer to
Chapter 20 for the jet valve servicing procedure.
This procedure is essentially the same as for the 2.6L engine covered
in Chapter 2, Part A. Refer to Part A, Section 6 and follow the procedure
outlined there (but also refer to the illustrations accompanying this Sec-
tion).
t
5.7 On adjustable-type rocker arms, back off the adjusters until
they only protrude 1 mm (0.040 in)
Identification mark
“““““,eDlf
Fo
For No. 2-4 cylinder
5.8b Exhaust-side rocker arms marked i - 3 are in the C
positions in illustration 5.8a, while exhaust rockers
marked 2 - 4 are installed in the D positions
.
6.1 Remove the valve guide seal with a pair of pliers
6.2 Gently tap the seal into place with a hammer and
I deep socket
To Next Page
Loading...
