2C-16
Chapter 2 Part C 3.01 V6 engine
INNER
ROTOR
CASE
\
4
+--MEASURE “A+*
MEASURE “8”
18.70~ Check for excessive clearance between the case and
inner rotor
19 FlywheeUdriveplate - removal and installation
This procedure is essentially the same for all engines. Refer to Part A
and follow the procedure outlined there, but use the bolt torque listed in
this Chapter’s Specifications.
20 Rear main oil seal - replacement
This procedure is essentially the same for all engines. Refer to Part A
and follow the procedure outlined there.
21 Engine mounts - check and replacement
Refer to illusffafion 27.7
This procedure is essentially the same for all engines. See Part A of
this Chapter and follow the procedure outlined there, but use the torque
values listed in this Chapter’s Specifications. Use the accompanying ex-
ploded view for reference
(see illustration).
21.1 An exploded view of the engine mounts (4WD Montero shown, others similar)
1 Front insu/afor
4 Number 2 crossmember 7 Stopper
10 f/ate assembly
2 Stopper 5 Heat shield
8 Transfer mounting bracket 11 Transfer support bracket
3 Heat shield
6 Rear insulator 9 Transfer support insulator
To Next Page
Loading...
