33
13. REMOVING the SIGNAL RECEIVING P.C. BOARD
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> for the wireless remote
controller.
(3) Remove the front panel.(see the photo 1)
(4) Remove the 2screws and signal receiving p.c. board cover.
(5) Remove the signal receiving p.c. board.
OPERATION PROCEDURE
PHOTOS & ILLUSTRATION
Set screws
Front
panel
Signal receiving p.c. board cover
Front
panel
Signal receiving p.c. board
(Photo 14)
(Photo 15)
OC330--2.qxp 05.5.9 1:29 PM Page 33
To Next Page
Loading...
