Mitsubishi S16R Series User Manual

7 SCHEDULED MAINTENANCE
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
129
Pub. No. K29001-00320 Revision: 1
*1: If the part is not supplied from Shanghai MHI Engine co., Ltd. (SME), service the part following the
supplier's operation manual.
*2: Service intervals vary depending on the use conditions. For details, see the rating definition "Rating
Definition" (→ Page 120).
Table 7-10 Scheduled Maintenance for Emergency Use Engine (5/5)
Inspection and
Maintenance Period
Service Items
Reference
Page
Service period
Every 8 years*2
• Engine - Major Overhaul
(Disassemble the engine, and then clean, check, and replace major
parts.)
• Damper - Replace
• Oil Pump - Repair or Replace
• Fuel Injection Nozzle Tip, Spacer, and Nozzle Spring - Replace
(Check the spray condition and adjust the fuel injection pressure after
the replacement.)
• Rubber Parts and O-rings - Replace
• Water Pump Unit Seal and Oil Seal - Replace
• Turbocharger - Disassemble and Inspect
• Air Cooler - Disassemble and Clean
• Vibration-isolating Rubber - Repair or Replace *1
• Couplings - Repair or Replace *1
• Governor Motor - Repair or Replace *1
• Indoor Ventilation Fan - Repair or Replace *1
• Stop Solenoid - Check or Replace
• Ball Tap of Water Tank - Repair or Replace *1
• Other Consumable Parts - Replace
8
(Contact your
SME dealer)

Mitsubishi S16R Series Specifications

General

Fuel Type	Diesel
Cooling System	Water-cooled
Starting System	Electric starter
Engine Type	4-cycle, water-cooled, direct injection
Aspiration	Turbocharged, Intercooled
Rotation	Counter-clockwise (viewed from flywheel side)
Fuel System	Direct injection
Lubrication System	Forced lubrication
Engine Model	S16R