MeasurLink
and U-WAVE
®
12
Installation
MeasurLink
®
Real-Time / Real-Time PLUS
MeasurLink Real-Time / Real-Time PLUS 6.1 should be installed on the
computer where you are adding the Mitutoyo U-WAVE wireless gage
multiplexer. If not, follow the instructions that come with the
MeasurLink Real-Time (PLUS) programs and perform a regular
installation. No special requirements are needed for the Mitutoyo U-
WAVE gage multiplexer.
If using an earlier version of the MeasurLink Real-Time (PLUS)
programs you must go to the MeasurLink Web site
www.measurlink.com
Support > Down loads > register for the user ID and password > then
in the down loads section go to the Service Packs folder. Down load
(save) the MeasurLink 6.1.xx program, do not try and run it across the
internet. After the down load is finished, then run the update program at
the MeasurLink computer.
To Next Page
Loading...