5
How to charge the helicopter
The helicopter
split charging device
all-in-one charging device
To meet the different demands from different customers worldwide, two
different charging devices have been designed for charging. One is split
charging device (1 piece charger +1 piece charge controller), the other one
is all-in-one charging device (one charger only)The product is included with
either of the two charging devices. User should check the package to confirm
which charging device is included before reading the charging method.
How to charge the helicopter by all-in-one charging device.
Unplug the battery cable from the helicopter, then, insert the plug of the
battery cable into the port of the charger (matching the plug to the port)
to start charging.
Once charging is proceeding, red light is on. When charging is finished,
the red light will turn into green light.
Full charge takes about 2 hours.
How to charge the helicopter by split charging device.
Unplug the battery cable from the helicopter.
Insert the plug of the battery cable into the quadrate port of the charge
controller (matching the plug to the port)
Insert the plug of the charger cable into the circular port of the charge
controller, then, connect the plug of the charger to AC power outlet to
start charging.
Once charging is proceeding, the red power light of the charge controller
is on. When charging is finished, both the red light and green light of the
charge controller are on.
Full charge takes about 2 hours.
connector
stabilizer bar
servo
Tail motor
rotor blade
searchlight
power socket
battery connector
Charging plug
camera
To Next Page
Loading...
