MJX F46 - Battery Notes and Flight Preparation; Battery safety and handling notes; Preparation for flight; Operational tips

6
Turn on the remote control. To activate the remote controller,slowly push
up the throttle stick to the top and then push it down to the bottom. The
remote controller is activated once you hear a beep sound.Then, the
vindicator light flashes rapidly while the remote controller is sending out
connectional signal.
Connect the battery plug to the helicopter battery cable,the indicator light
of the helicopter will keep slowing flashing,set the helicopter down to a
platform. Once the helicoter receives the connecting signal,the indicator
light of the helicopter will keep flashing rapidly to check the gyro.
Preparation for flight
When the whole auto signal connection process is finished,both
indicatorlights of helicopter and transmitter are keep “ON” without
blinking,then push up the throttle stick slowly and the helicopter takes off.
1.User may push either of the control sticks to skip the auto signal connection
process once the helicopter finished signal connection.
2.Set the connection one by one. Otherwise, it may not be connected.
3.Once the transmitter is turned off, the connection procedure must be repeated
to operate the helicopter.
4.Please pull out the battery plug from the helicopter battery socket.
OPERATIONAL TIPS
Check and regulate the swashplate of the helicopter
The swashplate of the helicopter should be kept horizontal, otherwise, the helicopter will fly
forward/backward/leftward/rightward automatically even though no control signal is given.
Hence, it is very important to check andconfirm that the swashplate is horizontal before flying
the helicopter. To get the swashplate horizontal, there are two ways available for regulation.