MK Controls Lightning Bug Plus - Page 11

When the
Lightning Bug Plus
firmware version by illuminating the LED’s. This version information will remain
displayed until the power button is released. This manual describes firmware
version 1.2
, which will be displayed as shown here:
After releas
ing the power button, the unit will then
(POST), which will light up all of the LED’s and perform an internal function
verification.
It will also send a signal to trip your cameras shutter.
POST you notice that
any LED’s fail to illuminate, please contact MK Controls
Technical Support for troubleshooting.
During power on, the Lightning Bug Plus
and automatically makes internal adjustments to the current light conditions
This process only takes about 1 second
LED will flash quickly.
The Lightning Bug Plus™
remembers important settings including the Frames per
Second, the Meter On/Off Mode,
To help preserve your camera battery, the
turn your meter off after
approximately
Rev: Version 1.2 June 16th, 20
2
Lightning Bug Plus
™ is first turned on,
it will display the current
firmware version by illuminating the LED’s. This version information will remain
displayed until the power button is released. This manual describes firmware
, which will be displayed as shown here:
ing the power button, the unit will then
execute a Power On Self
(POST), which will light up all of the LED’s and perform an internal function
It will also send a signal to trip your cameras shutter.
If during the
any LED’s fail to illuminate, please contact MK Controls
Technical Support for troubleshooting.
During power on, the Lightning Bug Plus
™
monitors the ambient incoming light,
and automatically makes internal adjustments to the current light conditions
This process only takes about 1 second
–
while making adjustments, the yellow
remembers important settings including the Frames per
Second, the Meter On/Off Mode,
and the Sensitivity;
these all will load at startup.
To help preserve your camera battery, the
Lightning Bug Plus™
will automatically
approximately
15 minutes of inactivity.
2
2 Page 11 of 26
it will display the current
firmware version by illuminating the LED’s. This version information will remain
displayed until the power button is released. This manual describes firmware
execute a Power On Self
-Test
(POST), which will light up all of the LED’s and perform an internal function
If during the
any LED’s fail to illuminate, please contact MK Controls
, Inc.
monitors the ambient incoming light,
and automatically makes internal adjustments to the current light conditions
.
while making adjustments, the yellow
remembers important settings including the Frames per
these all will load at startup.
will automatically