25
MK-100 OPERATION
(D)
Perform the cut. Turn the motor
OFF when work is complete.
45° Miter Cutting
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
To cut 45° Miters, the 45° Bullnose Miter Guide should be used (MK Diamond
Part # 134585-MK).
CAUTION
NOTE:
(A)
Position the 45° Bullnose
Miter Guide and tighten the
retaining thumbscrews.
(B)
Position the tile on the 45°
Bullnose Miter Guide and the
Ruler/Stop. Turn ON the motor.
(C)
Verify proper cooling ow on
both sides of the blade (See
Maintenance Section to
increase/decrease ow).
(D)
Perform the cut. Turn the motor
OFF when work is complete.
To Next Page
Loading...
