MK MK-100 - Setup and Operation Preparation; Pre-Start Inspection

20
Prior to beginning work, a pre-start inspection of the saw should be performed.
(A)
Ensure the ON/OFF Switch
is in the OFF position.
(B)
Verify the Movable Cutting
Table moves freely.
(C)
Inspect the Diamond Blade for
damage. Verify the blade is cor-
rect for the material being cut.
PRE-START INSPECTION
(D)
Inspect the Pump Assembly
for damage. Ensure the cord
is free of cracks or cuts.
(E)
Inspect the MK-100 for
damage. Ensure the cord is
free of cracks or cuts.
MK-100 TILE SAW SETUP