29
CLEANUP
If an external water source was used, steps A through C may be skipped.
Dispose of waste water in accordance with applicable Federal, State and Local laws.
(A)
Clean the Water Pump
suction of all debris
NOTE:
(B)
Place the Water Pump in an
external container
MK-100 CLEANUP
(C)
Run the MK-100 until clear
water is seen at the blade
cooling ports (Approx. 1 min.)
(D)
Remove the Water Basin
and clean.
(E)
Clean the Movable
Cutting Table Roller Wheel
and Frame Support
(F)
Clean the remainder of the
MK-100
To Next Page
Loading...
